Subaru Crosstrek and XV Forums banner

Camshaft position Sensor

3 reading
18K views 8 replies 4 participants last post by  TJB42  
#1 ·
Hello everyone,

Trying to track down an issue on my girlfriend's 2019 Crosstrek, 80,000 miles.

Check engine light comes on and it's giving:

P000A - a camshaft Position slow response(Bank 1)

Secondary- P0011 -Intake Camshaft Position timing (Bank 1)

P2400 - evaporative emission system leak detection pump control circuit/open

P2200 - NOx Sensor Circuit Bank 1


These leave me with two questions I was hoping to run by you all here in case someone with some experience can bail me out.

1. Can I get confirmation that bank one is passenger side, so I can know for sure to replace the correct sensor, top of passenger side of the engine?

2. Any clue what is up with these abs codes? Apparently these all came up at once and I'm not sure what any correlation may be.

Thank you all in advance. Apologies for any formatting or placement issues, new to the forum.
 
Discussion starter · #6 ·
Hey Doug thanks for all the looking.

I'll be working through these this weekend and I'll update the thread for posterity but, some concerns after digging a bit deeper into the codes here and on my own.

Will be back for future users and to let you know how it shakes out.

Thanks,
TJ
 
Discussion starter · #9 ·
Any updates? My 2019 crosstrek has exactly the same thing. :/
Hello,

Sorry for not updating as promised. We cleared the codes and they did not return on the vehicle. This lasted for at least a few months. It was not my vehicle and me and this girl broke up so I could not say if it was still a non issue haha.

I think the other advice in this thread is a good direction to head in and has good general information. I was planning on replacing sensors myself before the problem seemed to be resolved.

I wish I could provide a more useful update. Apologies for that.

TJ