Subaru Crosstrek and XV Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Wheel Tire Vehicle Land vehicle Car

I purchased Toyo AT III and Motegi MR139 (+15 offset) with a 1.5inch lift kit

Combo looks great but I got some rubbing going on.

I lowered the PSI from 36 to 33 and seem to help a little bit. I got quite a bit of rubbing when I turn full lock which I have to do in order to get out of my dead end street with a k turn.

I just purchased a heat gun with hopes of molding the plastic just enough.
I was really hoping I wouldn’t have to do any mods with thinking these would just fit.

any suggestions out there on what else can be looked at or is the heat gun to plastic the only route?
 
1 - 2 of 2 Posts
Top